-
Week 5 Engineering notebook




















9/21/18





Today we started coding to make sure that the cortex and control were in sync, we left our flash drive at home so we could not accurately save. Then we started brainstorming on some ideas about the claw  about the claw and came to a conclusion that the ones on the top shelf were not going to cut it, So I went to you tube to find the perfect claw but there was no luck yet. Then I decided to build the base.

Comments

Post a Comment

Popular posts from this blog

-
Image
Week 7 Engineering notebook                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                                              10/5/18         Today we found the claw  that we are going to use, we first started using the regular claw arms in the green bucket. Then, we found out that it didn't work the way
Read more
-
Image
Week 8 Engineering notebook 10/17/18 Today we are trying to finish up on our crane arm and in Solidworks we added the chassis body for the crane arm using 2x2x20 rails and standoffs. Also we put all the bearing flats for the motors on the standing c channels.
Read more
-
Image
    Week 6 Engineering notebook                                                                                                                                                                                                                                                                                           9/27/18                                                                                                                                                                                                                                                                                                                            In Solidworks we are almost done with making chassis and all that's left to do is to put the shaft collars on the shafts and to center the cortex between the two 2x1x35 rails. We also have ideas to build to crane arm chassis.                                                                                                                                   
Read more